ESU Power Pack Mini energy buffer for LokPilot V4.0 & LokSound V4.0 family, 1F/2.7V
ESU PowerPack Mini can be wired to all fourth generation ESU decoders. It reliably supplies energy
to your locomotive when traversing dirty track or long turnout ladders.
energy storage (1 Farad capacity) the unit supplies power to all light and motor functions as well
as to the sound module. Subject to the energy consumption of your model it may continue to move
for up to three seconds.
PowerPack Mini incorporates an integral charging circuit controlled by the decoder. Therefore it
may be connected even during programming. In order to avoid an undue load on the booster in case
there are several models in the same booster sector, the charging current is
buffer time can be reduced by means of a CV. This may be useful to assure the correct stopping
position ahead of signals showing the “Stop” aspect (red signal).
it is considerably smaller than its predecessor, the space requirements of the PowerPack Mini of
about 15.7 mm x 9.7 mm x 13 mm must be taken into account when installing this
pole wire harness connects the PowerPack Mini to the decoder. The wires are
already soldered to the PowerPack Mini and must be soldered to the appropriate solder pads of the